Procedure

Once you have purchased your “Mould Your Man” kit and have made a decision to make your mould here are a few recommendations designed to assist you with preparing for the process.

We encourage you to read these fully as they will help make the experience more enjoyable, memorable and a great deal easier.

You should have a willing and hands on partner with you for the entire moulding process as they will be a very valuable help in preparing you for your moulding (wink wink) The actual time taken for the moulding process, including the cleaning up, is generally no longer than 15 minutes.

Recommendations:

1. Whilst the products contained within our kits are all totally non-toxic and non-allergenic the moulding mixture does have a nasty habit of holding onto a few, if not more, of your “short & curlies”!! Therefore we recommend that you either shave the region around the base of your “Old Fella” along with your “Ball Bag” or alternately you trim them closely to prevent their anticipated but unfortunate removal when you remove yourself once the moulding mixture has set. For those of you who wish to remain wild & woolly then that is your prerogative, however you will end up a few pubes short of what you started with……ouch!!
2. We also recommend that you apply a covering of Vaseline to your remaining pubes to act as a mould release agent. You can use most Vaseline based skin conditioners or a normal skin lotion. Where at all possible, do not get the Vaseline/cream on the penis as it may react with the moulding mixture. Also it is recommended that you dampen your penis with a wet wash cloth before inserting it into the moulding mixture. This is something that your hands on assistant will be able to do for you!!
3. Timing is of the essence with the moulding process as you only have three (3) minutes from the time the moulding powder is emptied into the water until the moulding mixture sets. So please ensure that you have everything to hand and that you will not be interrupted during this time. Once the moulding mixture has set leave your penis in the sleeve containing the set mould for approximately 60 seconds before gently withdrawing it.
4. An erect penis is the best to mould so this is over to you and your willing, hands on helper! You must be able to maintain an erect penis for at least three (3) minutes so as not to suffer any undue shrinkage in your mould!! The water is a pleasant 27°C so there should be no nasty cold shocks here!!
5. The mould will generally create a near perfect replica of your penis including any lumps, bumps or veins all of which will be recreated in your silicone rubber replica Dildo/Vibrator.

Additionally your “Mould Your Man” DIY Kit contains very detailed “directions of use” and we recommend that you read these carefully and understand them fully before attempting to make your mould.